Speakerphone; Autoanswer With Headset Or Speakerphone - Cisco DX650 User Manual

Speakerphone

Speakerphone
If the handset is in its cradle and
trigger speakerphone mode automatically.
Speakerphone is unavailable while headphones, or a headset with an incompatible microphone, are plugged
in.
If you want to...
Toggle speakerphone mode on or off
Switch to a handset
Adjust the volume level for a call

AutoAnswer with headset or speakerphone

When AutoAnswer is enabled, your phone answers incoming calls automatically after a few rings. Your
system administrator configures AutoAnswer to use either the speakerphone or a headset. You may want to
use AutoAnswer if you receive a high volume of incoming calls.
If you...
Use AutoAnswer
with a headset
Use AutoAnswer
with the
speakerphone
AutoAnswer is disabled when the Do Not Disturb feature is active.
Note
Cisco Desktop Collaboration Experience DX600 Series User Guide, Release 10.0(1)
8
is not lit, many actions that you take to dial a number or answer a call
Then...
Press
Lift the handset.
Press
Then...
Keep headset mode active (in other words, keep
a call.
To keep headset mode active, perform the following actions:
• Press EndCall to hang up.
• Press New Call or Dial to place new calls.
If your phone is set up to use AutoAnswer in headset mode, calls are automatically
answered only if is lit.
Otherwise, calls ring normally and you must answer them manually.
Keep the handset in the cradle and headset mode inactive (
Otherwise, calls ring normally and you must answer them manually.
.
during a call or after invoking a dial tone.
lit), even when you are not on
Phone features
unlit).
OL-28931-01