Table of Contents
Advertisement
For details about how to specify the path using Browse Network, see "Locating the SMB folder using
browse network".
17.
Press [Connection Test] to check the path is set correctly.
18.
Press [Exit].
If the connection test fails, check the settings, and then try again.
19.
Press [OK].
20.
Press [Exit].
21.
Press the [User Tools] key.
• To register the name, see "Registering Names".
• You can enter up to 64 characters for the user name.
• You can enter up to 64 characters for the password.
• You can enter a path using up to 128 characters.
• If User Authentication is specified, contact your administrator.
• p.254 "Registering Names"
Locating the SMB folder manually
This section describes how to locate the SMB folder manually.
1.
Press [Change] right "Path".
2.
Enter the path where the folder is located.
3.
Press [OK].
If the format of the entered path is not correct, a message appears. Press [Exit], and then enter the
path again.
• Enter the path using this format: "\\ ComputerName\PathName".
• You can also enter an IPv4 address.
• You can enter a path using up to 128 characters.
Locating the SMB folder using browse network
This section describes how to locate the SMB folder using Browse Network.
Registering Folders
6
273
Advertisement
Table of Contents
