Table of Contents
Advertisement
5. Monitoring and Configuring the Printer
add_sess_IPX: bad trap addr: <IPX address> community <community name>
The IPX address (00:00:00:00:00:00) is unavailable when the community access type is TRAP. Specify
the host IPX address for the TRAP destination.
add_sess_IPX: community <community name> already defined.
The same community name already exists. Use another community name.
adjust time server <NTP server name> offset: xx sec.
ncsd tells you the timing of the NTP server and whether or not the time system clock is set.
• NTP Server: NTP server name
• offset: number of seconds of delay (minus number if a time in advance is specified)
Attach FileServer=<file server>
Connection to the file server as the nearest server has been established.
5
Attach to print queue <print queue name>
The system connects to the print queue when the print server goes online.
child process exec error !
The network service failed to start. Turn the printer off and then on. If this does not work, contact your service
or sales representative.
connected DHCPv6 server <IPv6 address>
The IP address was successfully received from the DHCPv6 server.
Could not attach to FileServer <error number>
Connection to the file server could not be established when the remote printer went online. The file server
refused the connection for unknown reason. Check the file server's configuration.
Could not attach to PServer <print server>
Connection to the print server has not been established when the remote printer is turned on. The print
server has refused the connection. Check the print server configuration.
connection from <IP address>
A user logged in from the host <IP address>.
Current Interface Speed: <Ethernet I/F Speed>
Speed of the network (10Mbps, 100 Mbps, or 1Gbps).
Current IPX address <IPX address>
The current IP address is <IPX address>.
242
Advertisement
Table of Contents
