3. Connecting the Machine
Connecting to the Ethernet Interface
This section describes how to connect Ethernet interface cable to the Ethernet interface.
• If the main power switch is on, turn it off.
• Use the following Ethernet cables.
• Unshielded Twisted Pair Cable (UTP) or Shielded Twisted Pair Cable (STP) and Category type
5 or more
3
1.
Make sure the main power switch of the machine is off.
2.
Connect the Ethernet interface cable to the 10BASE-T/100BASE-TX port.
3.
Connect the other end of the Ethernet interface cable to a network connection device such
as a hub.
4.
Turn on the main power switch of the machine.
1. Indicator (green)
Lights up green when the machine is connected correctly to the network.
2. Indicator (yellow)
Lights up yellow when 100 BASE-TX is in operation. Goes off when 10 BASE-T is in operation.
102
CCJ002
2
1
BRV035S