Table of Contents
Advertisement
Remote Maintenance by telnet
• Remote Maintenance should be protected so that access is allowed to administrators only.
• The password is the same as the one of Web Image Monitor administrator. When the password is
changed using "mshell", other's change also.
Using telnet
Follow the procedure below to use telnet.
• Only one user at a time can log on to perform remote maintenance.
• If you are using Windows Vista/7, you must enable the telnet server and telnet client beforehand.
1.
Use the IP address or the host name of the machine to start telnet.
% telnet "IP address"
2.
Enter your user name and password.
For details about the user name and password, consult your network administrator.
For user authentication, enter a login user name and password.
For user code authentication, enter a user code in User Name.
3.
Enter a command.
4.
Quit telnet.
msh> logout
The configuration message about saving the changes appears.
5.
Enter "yes" to save the changes, and then press the [Enter] key.
If you do not want to save the changes, enter "no", and then press the [Enter] key. To make further
changes, enter "return" at the command line, and then press the [Enter] key.
• If the message "Can not write NVRAM information" appears, the changes are not saved. Repeat the
procedure above.
• When the changes are saved, the network interface board is reset automatically with that changes.
• When the network interface board resets, the print job in print process will be printed. However, print
jobs in queue will be canceled.
Remote Maintenance by telnet
5
175
Advertisement
Table of Contents
