Add/Edit Internet Connection - ZyXEL Communications NR/FWA Outdoor Series User Manual

7.2.1 Add/Edit Internet Connection

Click the Edit icon (
to configure a WAN connection.
Figure 50 Network Setting > Broadband > Add/Edit New WAN Interface
The following table describes the labels in this screen.
Table 17 Network Setting > Broadband > Add/Edit New WAN Interface (Routing Mode)
LABEL
General
Name
Type
IPv4/IPv6 Mode
Routing Feature
NAT
Apply as Default
Gateway
IPv6 Routing Feature
Apply as Default
Gateway
Cancel
Apply
Chapter 7 Broadband
) next to an existing WAN interface to open the following screen. Use this screen
DESCRIPTION
Click this switch to enable or disable the interface. When the switch goes to the right, the
function is enabled. Otherwise, it is not.
This is the service name of the connection.
This shows the connection type.
Select IPv4 Only if you want the Zyxel Device to run IPv4 only.
Select IPv6 Only if you want the Zyxel Device to run IPv6 only.
Select IPv4 IPv6 DualStack to allow the Zyxel Device to run IPv4 and IPv6 at the same time.
Click this switch to activate or deactivate NAT on this connection. When the switch goes to the
right, the function is enabled. Otherwise, it is not.
Click this switch to have the Zyxel Device use the WAN interface of this connection as the system
default gateway. When the switch goes to the right, the function is enabled. Otherwise, it is not.
Select this option to have the Zyxel Device use the WAN interface of this connection as the
system default gateway.
Click Cancel to exit this screen without saving.
Click Apply to save your changes.
NR/FWA Outdoor Series User's Guide
78