Setting Method - SMC Networks ITV1000 series Operation Manual

Setting method

① If the incorrect key is pressed or incorrect information is displayed during
setting, power must be shut off and the procedure started again.
② It is recommended that the settings are changed without supply pressure. The
product operates immediately maximum and minimum pressures are set and the
Ｓ-key is pressed.
It is recommended that the minimum pressure is output when air is supplied
③
to the inlet, even if the input signal has not been entered.
Output pressure from this product and state of operation are changed by
④
changing of each setting and function. Each setting and function should be
operated by trained and experienced operator.
Flow of the setting
POWER ON
UNLOCK KEYS
SETTING OF PRESET PRESS.
SETTING OF MIN. PRESS.
SETTING OF MAX. PRESS.
SETTING OF SWITCH OUT.
（Note 1）: Please refer to each contents about operation methode.
（Note 2）: The function of the setting of preset pressure is preset input type
only.
（Note 3）: The function of the setting of switch output is switch output type
only.
REFER TO P8
REFER TO P9-11 REFER TO P13-16
DETAIL SETTING
△
CAUTION
！
REFER TO P11
RESET
GAIN
SENSITIVITY
ZERO CLEAR
INITIALIZE
―7―
REFER TO P8
LOCK KEYS