Ricoh A229 Service Manual page 238

Rev. 12/15/98
Mode No.
(Class 1 , 2 & 3)
1-002 Side-to-Side Registration
6 By-pass Tray
7 LCT
1-003 Paper Feed Timing
1 Tray, Duplex
2 By-pass Tray
1-007 By-pass Feed Paper Size Display
1-008 Duplex Fence Adjustment
1-103 Fusing Idling
1-104 Fusing Temperature Control
SM
Function
* Adjusts the printing side-to-side
registration from the by-pass feed table
using the trimming area pattern (SP2-902-
3, No.10).
Use the "•" key to toggle from + to - and
the Clear/Stop key to toggle from - to +
before entering the value.
The specification is 0 ±2.0 mm.
* Adjusts the printing side-to-side
registration from the LCT using the
trimming area pattern (SP2-902-3, No.10).
Use the "•" key to toggle from + to - and
the Clear/Stop key to toggle from - to +
before entering the value
The specification is 0 ±2.0 mm.
* Adjusts the relay clutch timing at
registration. The relay clutch timing
determines the amount of paper buckle at
registration. (A +ve setting leads to more
*
buckling.)
Displays the paper width sensor data for
the by-pass feed table.
132 : A3
133 : A4 Lengthwise
134 : A5 Lengthwise
141 : B4 Lengthwise
142 : B5 Lengthwise
160 : DLT
164 : LG
166 : LT Lengthwise
172 : HLT Lengthwise
* Adjusts the distance between the front and
rear fences.
Use the "•" key to toggle from + to - and
the Clear/Stop key to toggle from - to +
before entering the value.
* Selects whether fusing idling is done or not.
If fusing is incomplete on the 1st and 2nd
copies, change the setting to a longer time.
This may occur if the room is cold.
Refer to "Detailed Section Descriptions - Fusing
Temperature Control" for more details.
* Selects the fusing temperature control
mode.
After changing the setting, turn the main
switch off and on.
4-11
SERVICE PROGRAM MODE
Settings
+9 ~ -9
0.1
mm/step
+ 0.0 mm
+9 ~ -9
0.1
mm/step
+ 0.0 mm
+9 ~ -9
1 mm/step
+ 0 mm
+4 ~ -4
0.5
mm/step
+ -1.0 mm
0: 5 min.
1/2
1: 10 min.
2: 15 min.
3: No idling
On/Off
control
Phase control
A229