Ricoh A229 Service Manual page 198

24. Install the original exit tray [A] (3 screws).
25. Connect the ARDF connector [B] to the socket at the rear of the copier.
26. Attach the face up decal [C] to the feed tray as shown.
27. Plug in the power cord, then turn on the main power switch and the operation
switch. The machine automatically enters the process control data initial setting
mode. This takes about 5 minutes.
NOTE: Do not turn off the main switch during the process control data initial setting
mode.
Do not make any copies until after SP2963 has finished in step 29.
28. Enter SP mode as follows:
1) Press the clear modes key.
2) Enter "107"
3) Hold down the clear/stop key for more than 3 seconds.
 
→ → → →
SM
[C]
[B]
 
→ → →
3-11
A229I521.WMF

COPIER (A229)
[A]
A229