Checking The Configuration; Configuring A Route Multi-Instance Between An Mce And A Site; Establishing The Configuration Task - Huawei AR1200 series Configuration Manual

Huawei AR1200 Series Enterprise Routers
Configuration Guide - VPN
The interface is bound to the VPN instance.
Step 4 Run:
ip address ip-address { mask | mask-length }
The IP address is configured.
----End

2.2.4 Checking the Configuration

Run the command display ip vpn-instance [ verbose ] [ vpn-instance-name ] to check the
previous configuration.
If the configuration is correct, you can view:
l
l
l
l
l
l
<Quidway> display ip vpn-instance verbose
Total VPN-Instances configured : 1
VPN-Instance Name and ID : vpn1, 1
Create date : 2011/09/10 16:58:42
Up time : 0 days, 21 hours, 42 minutes and 10 seconds
Log Interval : 5
2.3 Configuring a Route Multi-Instance Between an MCE
and a Site
This section describes how to configure static routes, RIP, OSPF, IS-IS, and BGP between an
MCE and a site.
For configuring a route multi-instance between an MCE and a
a Static Route Between an MCE and a Site
and a Site are optional and can be configured as required.

2.3.1 Establishing the Configuration Task

Applicable Environment
To connect a CE to multiple VPNs and isolate services of these VPNs, you need to configure
MCE functions. Before configuring MCE functions, you need to perform the task of
Configuring a VPN Instance
between an MCE and a site.
Issue 01 (2012-04-20)
NOTE
The running of the ip binding vpn-instance command on an interface can delete the Layer 3 attributes,
such as the IP address and routing protocol. If these Layer 3 attributes are still required, you need to
configure them again.
VPN instance created correctly
Name of the VPN instance
RD
Description
Maximum number of routes supported by the VPN instance
Interface configured correctly
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
to (Optional) Configuring BGP Between an MCE
on the MCE and PE and then configure a route multi-instance
2 MCE Configuration
site,2.3.2 (Optional) Configuring
2.2
46