Huawei AR1200 series Configuration Manual page 90

Huawei AR1200 Series Enterprise Routers
Configuration Guide - VPN
l
Issue 01 (2012-04-20)
NOTE
For details, see the chapter "IP Static Route Configuration" in the Huawei AR1200 Series Enterprise
Routers Configuration Guide - IP Routing.
1. Run:
system-view
The system view is displayed.
2. Run:
ip route-static vpn-instance vpn-source-name destination-address { mask
| mask-length } interface-type interface-number [ nexthop-address ]
[ preference preference | tag tag ]
The static route is configured for the specified VPN instance IPv4 address family.
3. Run:
bgp as-number
The BGP view is displayed.
4. Run:
ipv4-family vpn-instance vpn-instance-name
The BGP VPN instance IPv4 address family view is displayed.
5. Run:
import-route static [ med med | route-policy route-policy-name ]*
The configured static route is imported into the routing table of the BGP VPN
instance IPv4 address family.
Configure RIP between a PE and a CE
Perform the following steps on the PE. The CE is configured with RIPv1 or RIPv2. The
configurations are common, therefore not mentioned here.
NOTE
For details, see Huawei AR1200 Series Enterprise Routers Configuration Guide - IP Routing.
1. Run:
system-view
The system view is displayed.
2. Run:
rip process-id vpn-instance vpn-instance-name
The RIP instance is created between the PE and the CE and the RIP view is displayed.
A RIP process belongs to only one VPN instance. If you run a RIP process without
binding it to a VPN instance, this process is considered as a public network process.
A RIP process that belongs to a public network cannot be bound with a VPN instance.
3. Run:
network network-address
The RIP is configured on the network segment of the interface bound with the VPN
instance.
4. Run:
import-route bgp [ cost { cost | transparent } | route-policy route-policy-
name ]*
The BGP route is imported.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 BGP MPLS IP VPN Configuration
*
79