Huawei AR1200 series Configuration Manual page 196

Huawei AR1200 Series Enterprise Routers
Configuration Guide - VPN
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
4.
Data Preparation
To complete the configuration, you need the following data:
l
l
Procedure
Step 1 Configure IGP on MPLS backbone of AS 100 and AS 200 respectively to make the PE and the
P reach each other in the same AS.
OSPF is used as the IGP in this example, the configuration procedure is not mentioned here.
After the configuration, the OSPF neighbor relationship should be established between the
ASBR and the PE of the same AS. Run the display ospf peer command to find that the status
of the OSPF neighbor relationship is "Full".
The ASBR and the PE in the same AS can learn the Loopback addresses of each other and can
ping through each other.
Step 2 Configure MPLS basic capability and MPLS LDP on the MPLS backbone of AS 100 and AS
200 respectively to setup LDP LSP.
For configuration procedures, see
Step 3 Configure basic BGP/MPLS IP VPN on the MPLS backbone of AS 100 and AS 200 respectively.
For configuration procedures, see the following configuration files.
Step 4 Configure inter-AS VPN Option B mode.
# Configure ASBR 1. Enable MPLS on GigabitEthernet2/0/0 connected with ASBR 2.
<ASBR1> system-view
[ASBR1] interface gigabitethernet 2/0/0
[ASBR1-GigabitEthernet2/0/0] ip address 192.1.1.1 24
[ASBR1-GigabitEthernet2/0/0] mpls
[ASBR1-GigabitEthernet2/0/0] quit
Issue 01 (2012-04-20)
Configure IGP on the backbone network to interconnect the ASBR and the PE in the same
AS. Set up MPLS LDP LSP between the ASBR and the PE in the same AS.
Set up the EBGP peer relationship between the PE and the CE. Set up the MP-IBGP peer
relationship between the PE and the ASBR.
Configure the VPN instance on the PE. (There is no need to configure the VPN instance
on the ASBR.)
Enable MPLS on the interface connected ASBRs. Set up the MP-EBGP peer relationship
between ASBRs. Configure no VPN-target filtration on the received VPNv4 routes.
MPLS LSR-ID on the PE and the ASBR
Name, RD and the VPN-Target of the VPN instance configured on the PE1 and PE2
NOTE
The 32-bit loopback interface address used as the LSR ID should be advertised by OSPF.
NOTE
The VPN target of the VPN instances of the PE1 and the PE2 should be matched.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Example for Configuring Inter-AS VPN Option
3 BGP MPLS IP VPN Configuration
A.
185