Huawei AR1200 Series Enterprise Routers
Configuration Guide - VPN
3.16.2 Configuring All Client CEs to Establish IBGP Connections
with the RR
This section describes how to configure an IBGP connection between the client (a CE) and the
RR to reflect VPNv4 routes.
Context
Perform the following steps on all Client CEs.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
bgp as-number
The BGP view is displayed.
Step 3 Run:
peer ipv4-address as-number as-number
The RR is specified as the BGP peer.
Step 4 Run:
peer ipv4-address connect-interface
interface-type interface-number
The interface is specified as an interface to establish the TCP connection.
The interface IP address must be the same as the MPLS LSR ID. It is recommended to specify
a loopback interface to establish the TCP connection.
----End
3.16.3 Configuring the RR to Establish MP IBGP Connections with
All Client CEs
This section describes how to configure MP-IBGP connections between the RR and all its clients
(CEs) to reflect VPNv4 routes to all clients (CEs).
Context
Perform the following steps on the RR.
Procedure
l
Issue 01 (2012-04-20)
Establishing the MP-IBGP Connection with the Peer Group
1.
Run:
system-view
The system view is displayed.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 BGP MPLS IP VPN Configuration
142