Configuring The Routing Protocol Between Ce And Pe; Checking The Configuration - Huawei AR1200 series Configuration Manual

Huawei AR1200 Series Enterprise Routers
Configuration Guide - VPN
Step 3 Run:
ipv4-family vpnv4
The BGP VPNv4 view is displayed.
Step 4 Run:
apply-label per-nexthop
The next-hop-based label allocation for IPv4 VPN routes is enabled on the ASBR.
After next-hop-based label allocation is enabled or disabled, the label allocated by the ASBR
for a route changes, which leads to packet loss.
----End

3.7.7 Configuring the Routing Protocol Between CE and PE

The routing protocol between a PE and CE can be BGP, static route, or IGP. You can choose
any of them as required in the configuration process.
Procedure
Step 1 Choose one of the preceding methods as required. For detailed configurations, see
Configuring a Routing Protocol Between a PE and a
----End

3.7.8 Checking the Configuration

After configuring inter-AS VPN Option B, you can view information about all the BGP peer
relationships and VPNv4 routes on PEs or ASBRs.
Prerequisites
The configurations of the inter-AS VPN Option B function are complete.
Procedure
l
l
l
l
----End
Issue 01 (2012-04-20)
CAUTION
Run the display bgp vpnv4 all peer command to check the VPN IPv4 routing table on the
PE or ASBR.
Run the display bgp vpnv4 all routing-table command to check information about all the
BGP peers on the PE or ASBR.
Run the display ip routing-table vpn-instance vpn-instance-name command to check the
VPN routing table on the PE.
Run the display mpls lsp command to check information about the LSP and label on the
ASBR.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 BGP MPLS IP VPN Configuration
CE.
3.4.6
103