Huawei AR1200 series Configuration Manual page 93

Huawei AR1200 Series Enterprise Routers
Configuration Guide - VPN
l
Issue 01 (2012-04-20)
8. Run:
quit
Return to the OSPF view.
9. Run:
quit
Return to the system view.
10. Run:
bgp as-number
The BGP view is displayed.
11. Run:
ipv4-family vpn-instance vpn-instance-name
The BGP VPN instance IPv4 address family view is displayed.
12. Run:
import-route ospf process-id [ med med | route-policy route-policy-name ]
The OSPF route is imported into the routing table of the BGP VPN instance IPv4
address family.
NOTE
After a VPN instance is deleted or the IPv4 address family of the VPN instance is disabled, all
related OSPF processes are deleted.
Configuring IS-IS between the PE and CE
Perform the following steps on the PE. The CE is configured with IS-IS. The configurations
are common, therefore not mentioned here.
NOTE
For details, see Huawei AR1200 Series Enterprise Routers Configuration Guide - IP Routing.
1. Run:
system-view
The system view is displayed.
2. Run:
isis process-id vpn-instance vpn-instance-name
The IS-IS instance between the CE and the PE is created and the IS-IS view is
displayed.
An IS-IS process belongs to only one VPN instance. If you run an IS-IS process
without binding it to a VPN instance, this process is considered as a public network
process. An IS-IS process that belongs to a public network cannot be bound with a
VPN instance.
3. Run:
network-entity net
The Network Entity Title (NET) is configured.
An NET defines the address of the current IS-IS area and the system ID of the
router. A maximum of three NETs can be configured for one process on a router.
4. (Optional) Run:
is-level { level-1 | level-1-2 | level-2 }
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 BGP MPLS IP VPN Configuration
*
82