Huawei AR1200 series Configuration Manual page 370

Huawei AR1200 Series Enterprise Routers
Configuration Guide - VPN
Data Preparation
To complete the configuration, you need the following data:
l
l
Procedure
Step 1 Assign an IP address to each interface.
Assign an IP address to each interface as shown in
mentioned here.
Step 2 Configure routes between the Routers.
# Configure RIP on the Ethernet interface of the hub
[Huawei] rip
[Huawei-rip-1] network 44.0.0.0
[Huawei-rip-1] version 2
[Huawei-rip-1] quit
# Configure RIP on the Ethernet interface of the Spoke1
[Huawei] rip
[Huawei-rip-1] network 44.0.0.0
[Huawei-rip-1] version 2
[Huawei-rip-1] quit
# Configure RIP on the Ethernet interface of the Spoke2
[Huawei] rip
[Huawei-rip-1] network 44.0.0.0
[Huawei-rip-1] version 2
[Huawei-rip-1] quit
Step 3 Configure RIP on the tunnel interfaces.
# Configure hub
[Huawei] rip 2
[Huawei-rip-1] network 172.16.1.0
[Huawei-rip-1] version 2
[Huawei-rip-1] quit
# Configure Spoke1
[Huawei] rip 2
[Huawei-rip-1] network 172.16.1.0
[Huawei-rip-1] version 2
[Huawei-rip-1] quit
# Configure Spoke2
[Huawei] rip 2
[Huawei-rip-1] network 172.16.1.0
[Huawei-rip-1] version 2
[Huawei-rip-1] quit
Step 4 Configure tunnel interfaces on the Routers and configure NHRP mapping entries of the hub on
Spoke1 and Spoke2.
# Configure a tunnel interface and enable NHRP redirect on the hub.
[Huawei] system-view
[Huawei] interface tunnel 0/0/0
Issue 01 (2012-04-20)
Reachable routes between the Routers
Source addresses of tunnel interfaces on the Routers
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 DSVPN Configuration
Figure 6-2. The specific configuration is not
359