Huawei AR1200 series Configuration Manual page 111

Huawei AR1200 Series Enterprise Routers
Configuration Guide - VPN
l
Issue 01 (2012-04-20)
bgp as-number
The BGP view is displayed.
3. Run:
ipv4-family vpnv4 [ unicast ]
The BGP-VPNv4 address family is displayed.
4. Run:
undo policy vpn-target
The VPN IPv4 routes are not filtered by the VPN target.
By default, the PE performs VPN target filtering on the received IPv4 VPN routes.
The routes passing the filter are added to the routing table, and the others are discarded.
If the PE is not configured with VPN instance, or the VPN instance is not configured
with the VPN target, the PE discards all the received VPN IPv4 routes.
In the Inter-AS VPN Option B mode, if the ASBR does not store information about
the VPN instance, the ASBR must save all the VPNv4 routing information and
advertise it to the peer ASBR. In this case, the ASBR should receive all the VPNv4
routing information without the VPN target filtering.
VPN Target Filtering
Perform the following steps on the ASBR:
1. Run:
system-view
The system view is displayed.
2. Run:
ip extcommunity-filter { basic-extcomm-filter-num | basic basic-extcomm-
filter-name | advanced-extcomm-filter-num | advanced advanced-extcomm-
filter-name } { permit | deny } { rt { as-number:nn | ipv4-address:nn } }
&<1-16>
The extended community filter is configured.
3. Run:
route-policy route-policy-name permit node node
The routing policy is configured.
4. Run:
if-match extcommunity-filter { { basic-extcomm-filter-num | advanced-
extcomm-filter-num } &<1-16> | advanced-extcomm-filter-name | basic-
extcomm-filter-name }
A matching rule based on the extended community filter is configured.
5. Run:
quit
Return to the system view.
6. Run:
bgp as-number
The BGP view is displayed.
7. Run:
ipv4-family vpnv4 [ unicast ]
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 BGP MPLS IP VPN Configuration
100