Set The Rotation Mode - Oce plotwave 345 Operation Manual

Set the rotation mode

Introduction
If you want to turn an image, you can use the rotation settings. The setting allows you to turn the
image according to predefined rotation values or you can let the printer perform the rotation
automatically.
Choose one of the following values:
• [No rotation]
• [90°]
• [180°]
• [270°]
• [Automatic portrait]
• [Automatic landscape]
• [Automatic portrait with additional 180° rotation]
• [Automatic landscape with additional 180° rotation]
• [Automatic media saving]
• [Automatic media saving with additional 180° rotation]
Procedure
1. Open the [Preferences] - [Print job defaults] tab.
2. Click on [Edit] in the [Layout] section or click on the [Rotation] setting.
3. Choose one of the values.
Select [Automatic media saving] or [Automatic media saving with additional 180° rotation] when
the print productivity is an important factor.
4. Click on [Ok] to confirm or [Cancel] to reject your entries.
Chapter 3 - Define your Workflow with Océ Express WebTools
Set the rotation mode
129