Recommended Settings For Copy Jobs - Oce plotwave 345 Operation Manual

Recommended settings for copy jobs

Recommended settings for copy jobs
Introduction
When you use a certain type of original document you can select specific presets and settings
that influence the quality and productivity of your job. Use the advised settings in the table below
to get the best results.
Workflow
1. Start by selecting the best image preset for your job. Use column two in the table below, or
for more information see
2. When you want to further optimize the settings, you can select the advanced settings, under
[Show all settings] on the user panel. When you want to influence the imaging process and
thus optimize the output quality, you can select the corresponding [Original type] for your job.
Use column three in the table below, or for more information see
jobs on page 169
Advised settings
Original document
Monochrome CAD Drawings
Folded monochrome CAD drawing
Monochrome CAD drawings with
marks from marker pens
Monochrome CAD drawings with
some color information that should
be emphasized
(Folded) Color CAD drawings, maps,
business graphics, etc.
CAD originals with a non uniform
background
Diazo copies / "Chinese blueprints"
Dark (transparent) originals
Photos and high-definition color
prints
Blueprints with white lines on a blue
background
NOTE
When setting [Color highlighting] to on, the color accents on a black an white drawing are kept
by copying the color information darker than the monochrome information. Note that [Color
highlighting] is not supported with the original type [Photo] and [Blueprint].
176 Chapter 4 - Use the Printing System
The Image preset for copy jobs on page
The original type on page
and
Preset [Image]
[CAD grayscale]
[CAD grayscale]
[CAD color]
[CAD color]
[CAD color]
[Diazo]
[Diazo]
[Diazo]
[Photo]
[CAD grayscale]
168.
Advanced settings for copy
177.
Optimize under [Show all settings]
Set the original type to [Folded lines/
text]
When 'color highlighting' is needed,
set [Color highlighting] to on.
When 'color highlighting' is needed,
set [Color highlighting] to on.
When 'color highlighting' is needed,
set [Color highlighting] to on.
Set original type to [Blueprint]