Hearth Mount Installation; Through Concrete Wall With Vertical Rise Installations - Enviro EVOLUTION Owner's Manual

H M I
EARTH OUNT NSTALLATION
Figure 19
T C
HROUGH ONCRETE
A 45° elbow with a rodent screen may be used
in place of the termination cap (or stainless
steel termination hood).
Installation to use if there is a concrete or
retaining wall in line with exhaust vent on pellet
stove.
The termination must be 12 inches (30 cm)
from the outside wall and 12 inches (30 cm)
above the ground.
20
Installation
:
���� ���
���� �����
�������� �������� ����
���� ���� ������� ����
��������� ���� ���� �� ��
�����
�������� ���� ���������
���� ���� � �� ������� ��
���� �� ���� ���� ���������
������ �� ����� ����� �
��������� ������
����� ��� ���
�������� ���������
�� �
W W V
ALL ITH ERTICAL
1. Lock fireplace damper in the open position.
2. Install positive flue connector at the fireplace
dampers.
3. Connect a Tee or a 90° degree elbow to the exhaust
pipe.
4. Install flexible stainless steel liner or listed pellet vent
to the top of the chimney.
R I :
ISE NSTALLATIONS
Horizontal frame
for thimble
Wall thimble
90 deg elbow
Wall framing
Vertical section
of vent pipe
Clean out tee
�� �
Figure 20
Termination cap
Concrete Wall