Hearth Mount Installation - Enviro Mini 2 Operator's Manual

Rain Cap
Flexible or
Rigid 6" Stainless
Steel Liner
H m i
eaRtH ount nStaLLation
Flue
Connector
Clean-out tee
Masonry Fireplace
Figure 29: Freestanding hearth mount installation.
22
Steel Plate or Flashing
Installation
:
Damper Removed
or Fastened Open
10" (25.4 cm) Mantel
Minimum 8" (20 cm)
from top of stove
Min 6" (150 mm)
Optional Hearth
Floor Protection
Combustible Floor
R
AUGE E
MOD
AUTO/ OW OFF
HIGH/L AL MANU
FEED RATE
TRIM
L BUST ION
HEAT LEVE COM TRIM ER
BLOW FF
ON/O
AIR
ON/O ROOM FF
FAN
Figure 30: Freestanding hearth mount installation overview.
Refer to Figures 29 and 30.
1. Install the hearth pad.
2. Lock the fireplace damper in the open
position.
3. Install a positive flue connector at the
fireplace dampers or seal the chimney at
the top.
4. Connect a tee to the exhaust pipe.
5. Install flexible stainless steel liner or listed
pellet vent to the top of the chimney.
or Other
Rain cap
Storm collar
Seal plate (cover plate)
Existing masonry flue
Vent pipe (single wall
stainless flex pipe or
solid PL vent)
Flexible vent connector
(use this 5 foot [152cm]
section of pipe to vent
past fireplace damper
or small shelf)
Fireplace damper
location
Clean out tee
Existing fireplace