Connecting Apollo; Connecting The Power; Connecting The Network Cable - Promise Technology Apollo User Manual

Follow the instructions below to connect the network cable and AC power adapter to the Apollo.
Attach the AC adapter power cord to the power insert on the back of the device. Plug the other end of the adapter into a
suitable power source.
Caution
You must use the AC power adapter shipped with the device. Using a different power
adapter can damage the device or might present an electrical safety hazard.
Use the included Ethernet cable to connect to the network port on the back of the device. Connect the other end to a
networking device that allows the Apollo to connect to the Internet, such as a broadband router, or office Ethernet LAN
that is connected to the Internet.
The Apollo does not require configuration of network settings or any other settings for initial system setup. Just make sure it has an
available path to the Internet.
Hardware Setup

Connecting Apollo

Connecting the Power

Connecting the network cable

4
Return to "Table of Contents"
Click here to get help online