Right Handlebar - Suzuki gw250F Owner's Manual

TURN SIGNAL LIGHT SWITCH
"%&" 4
Moving the switch to the "%" position
will flash the left turn signals. Moving
the switch to the "&" position will
flash the right turn signals. The indi-
cator light will also flash intermittently.
To cancel turn signal operation, push
the switch in.
! WARNING
Failure to use the turn signals,
and failure to turn off the turn sig-
nals can be hazardous. Other driv-
ers may misjudge your course and
this may result in an accident.
Always use the turn signals when
you intend to change lanes or
make a turn. Be sure to turn off
the turn signals after completing
the turn or lane change.
HORN SWITCH "+" 5
Press the switch to sound the horn.
Hazard Warning Switch "," 6
ON
All four turn signal lights and indica-
tors will flash simultaneously when
the switch is turned on with the igni-
tion switch in the "ON" position. Use
the hazard warning lights to warn
other traffic during emergency park-
ing or when your motorcycle could
otherwise become a traffic hazard.

RIGHT HANDLEBAR

ENGINE STOP SWITCH 1
"-" position
The ignition circuit is off. The engine
cannot start or run.
"$" position
The ignition circuit is on and the
engine can run.
FRONT BRAKE LEVER 2
The front brake is applied by squeez-
ing the brake lever gently toward the
throttle
equipped with a disk brake system
and
required to slow the motorcycle down
properly. The brake light will be lit
when the lever is squeezed inward.
OFF
2-15
grip. This
excessive pressure
motorcycle is
is not