Suzuki gw250F Owner's Manual page 19

If the tachometer needle does not
point to zero, follow the procedure
below to reset the tachometer.
1. Press and hold the ADJ button B
and turn on the ignition switch.
2. Hold the ADJ button B for 3 – 5
seconds.
3. Release the ADJ button B. Rap
the ADJ button twice.
NOTE: Reset procedure, from step 1
to step 3, should be performed within
10 seconds.
COOLANT TEMPERATURE
INDICATOR LIGHT """ 1
This indicator light comes on when
the coolant temperature is too high.
This indicator light should come on
when the engine is not running. As
soon as the engine starts, this indica-
tor light should go out.
When the coolant temperature indica-
tor light comes on, stop the engine
and check the coolant level after
engine cools.
NOTICE
Riding the motorcycle with the
coolant temperature indicator lit
can cause serious engine damage
due to overheating.
If the engine coolant temperature
indicator light comes on, stop the
engine to let it cool. Do not run the
engine until the coolant tempera-
ture indicator light goes off.
OIL PRESSURE INDICATOR LIGHT
"#" 2
This indicator comes on when the
engine oil pressure is below the nor-
mal operating range. This should
come on when the ignition switch is
"ON" and the engine is not running.
As soon as the engine starts, this
should go out.
NOTICE
Riding the motorcycle with the oil
pressure indicator light lit can
damage the engine and transmis-
sion.
If the oil pressure indicator light
comes on, indicating low oil pres-
sure, stop the engine immediately.
Check the oil level and add oil if
necessary. If there is a proper
amount of oil and the light still
does not go out, have your autho-
rized Suzuki dealer or a qualified
mechanic inspect your motorcy-
cle.
2-7