RIGHT HANDLEBAR
Engine Stop Switch 1
"" position
The ignition circuit is off. The
engine cannot start or run.
"" position
The ignition circuit is on and the
engine can run.
Front Brake Lever 2
Apply the front brake by squeez-
ing the front brake lever towards
the grip. The brake light will come
on when the lever is squeezed.
Electric Starter Button "" 3
Use this button to operate the
starter motor. With the ignition
switch in the "ON" position, the
engine stop switch in the ""
position, and the transmission is
in neutral, pull in the clutch lever
and push the electric starter but-
ton to start the engine.
NOTE: This motorcycle has a
starter interlock system for the
ignition and starter circuit. The
engine can only be started if:
•
The transmission is in neutral
and the clutch is disengaged,
or
•
The transmission is in gear,
the side stand is fully up and
the clutch is disengaged.
NOTE: The headlight will go off
when the electric starter button is
pushed.
CAUTION
To prevent electrical system
damage, do not operate the
starter motor longer than 5
seconds at a time.
If the engine does not start
after several attempts, check
the fuel supply and ignition
system. Refer to the TROUBLE-
SHOOTING section in this man-
ual.
3-16