Suzuki gw250F Owner's Manual page 88

3. Loosen the axle holder bolt 2.
4. Loosen the axle shaft 3 tempo-
rarily.
NOTE: A special tool is necessary to
loosen the axle shaft 3. The special
tool is available at Suzuki dealer.
5. Place an accessory service stand
or equivalent under the swingarm
to help stabilize the rear end.
6. Carefully position a jack under the
engine and raise until the front
wheel is slightly off the ground.
NOTICE
Improper jacking may cause dam-
age to the oil filter.
Do not place the jack under the oil
filter when jacking up the motorcy-
cle.
7. Turn the axle shaft counterclock-
wise and draw it out.
8. Slide the front wheel forward.
9. To reinstall the wheel assembly,
reverse the sequence described
above.
10. After installing the wheel, apply
the front brake several times to
restore the proper lever stroke.
6-38