After-Race Check Points; Important Recommendation; After Washing; Appendix - Husqvarna TE 250 - 310 2011 I.E. Specifications - Operation - Maintenance

APPENDIX

AFTER-RACE CHECK POINTS

After racing, first clean the motorcycle and then inspect the
entire motorcycle, with special attention to the items listed in
«MAINTENANCE» table (Appendix A), such as the air cleaner,
carburetor, brakes, etc.
Carry out general lubrication, and make adjustment as neces-
sary.
- Lubricate the drive chain and all the cables.
- Spray oil on all unpainted metal surfaces to prevent rusting.
Avoid getting oil on rubber parts or in the brakes.
- Set the motorcycle on a box or stand so that both wheels are
raised off the ground. (If this cannot be done, put boards un-
der the front and rear wheels to keep dampness away from
the tire rubber).
- Tie a plastic bag over the exhaust pipe to prevent moisture
from entering.
- Put a cover over the motorcycle to keep dust and dirt from
collecting on it.
To put the motorcycle back into the use after storage.
- Make sure the spark plug is tight.
- Fill the fuel tank.
- Run the engine to warm the oil then drain the oil.
- Put in fresh transmission oil.
- Check all the points listed under the inspection and Adjust-
ment Section (Appendix A).
- Lubricate the points (listed in the Lubrication Section (Appen-
dix A).
EN - 54
CLEANING

IMPORTANT RECOMMENDATION

Premised that, before the motorcycle washing, it is necessary to
protect opportunely from the water the following parts:
a) Rear opening of the muffler;
b) Clutch and brake levers, hand grips, handlebar commuta-
tors;
c) Air cleaner intake;
d) Fork head, wheel bearings;
e) Rear suspension links,
It is necessary ABSOLUTELY TO AVOID THAT
HIGH PRESSURE JETS OF WATER OR AIR come
to contact with THE ELECTRICAL PARTS AND
FUEL INJECTION PARTS, especially the elec-
tronic control unit and the sensors group
M.A.Q.S. and the dashboard.

After washing

- Remove the plastic bags, and clean the air cleaner intake.
- Lubricate the points listed in the Maintenance Table (Appendix A).
- Briefly warm-up the engine
- Test the brakes before riding the motorcycle.
WARNING*: Never wax or lubricate the
brake disc. Loss of braking and an accident
could result. Clean the disc with an oilless
solvent such ans acetone. Observe the sol-
vent warnings.