Install The Rudder And Elevator Servo - GREAT PLANES ULTRA SPORT 46 Instruction Manual

11. Test fi t the rudder, checking that it moves without
binding.
12. Use 6-minute epoxy to glue the tail gear bearing in
the fuselage.
13. Insert a T-pin into the center of both CA hinges.
14. Insert the hinges into the trailing edge of the vertical
fi n, up to the T-pin. Note the direction of the slot.
15. Apply 6-minute epoxy to the torque arm of the tail
gear and slide the rudder onto the CA hinges and torque
arm. Remove the T-pins and apply 6 drops of thin CA to
both sides of each CA hinge. Test pull the rudder to make
sure the hinges are secure.
16. Install the tail wheel and wheel collar.

Install the Rudder and Elevator Servo

1. Insert the rudder and elevator pushrods. Use the
pushrods to position the rudder and elevator servos.
2. Mount the two servos using the screws included with
the servos. Harden the screw holes with thin CA
3. Install the on/off switch and the charge receptacle. Note:
If the plane is to be fl own as electric and the recommended
ESC is used, the on/off switch, receiver battery and charge
receptacle are not needed.
14