Join The Wing Panels - GREAT PLANES ULTRA SPORT 46 Instruction Manual

Join the Wing Panels

1. Glue the two plywood wing joiners together.
2. Install the 5 x 25mm nylon alignment pin.
3. Route the servo leads out the two holes in the top of
the wings.
4. Install the two 8 x 30mm nylon wing dowels.
5. Without glue, insert the plywood wing joiner in one
wing half and test fi t the wing halves together to check the fi t.
Make sure both wing halves fi t together at the root without
any gaps.
6. Gather everything needed to glue the two wing halves
together including 30-minute epoxy, mixing sticks, mixing cup,
epoxy brush, #64 rubberbands, masking tape, 12" (305mm)
long wire or small diameter dowel, denatured alcohol and
paper towels.
7. Mix 2 oz. (59.1cc) of 30-minute epoxy. Working quickly,
pour a generous amount into the joiner pocket of one wing
half. Use the wire or dowel to thoroughly distribute the epoxy,
9