Install The Retracts - GREAT PLANES ULTRA SPORT 46 Instruction Manual

coating all surfaces inside the joiner pocket. Coat the root rib
and one half of the wing joiner. Insert the wing joiner in the
wing. Coat the joiner pocket in the other wing half and the
other end of the wing joiner. Join the wing halves together.
Use the rubberbands to hold the leading and trailing edges
of the wing together. Stand the wing up on end and use
paper towels dampened with denatured alcohol to remove
the excess epoxy that squeezes out. Use masking tape to
hold the wing halves in alignment if necessary.
8. After the epoxy cures, remove the rubberbands and
masking tape.

Install the Retracts

1. The retract servo tray is cut to fi t the Futaba S3170G
retract servo. If the Tower Hobbies TS-63 retract servo is
used, the tray can be trimmed with a hobby knife along the
embossed lines.
2. Install the retract servo tray.
3. Install the retract servo.
4. Remove the four set screws from each retract.
5. Install the gear legs so that the coil is toward the trailing
edge. Tighten a set screw onto the fl at of the gear leg from
each side. Then tighten the second set screw against the fi rst.
10