Status Flags Description [63,0,119; Status Flags; D.8 Status Flags Description [63,0,119] - Emerson DL8000 Instruction Manual

DL8000 Preset Instruction Manual
D.8

Status Flags Description [63,0,119]

Status Flag
Additive Selected
Batch Aborted (not started)
Batch Authorized
D-80
The following table describes activities that set or reset status flags.
Table D-4. Status Flag Descriptions
Flag sets when...
Operator selects additive through
keypad.
Note: If TAS writes additive
selection to [63,0,60] then
flag does not change.
Operator presses Stop key for

authorized batch after entering
preset volume (in manual
mode).
Operator issues Stop Batch

command for authorized batch
which is not in progress (in auto
mode).
TAS issues End Batch

command for authorized batch
which is not in progress (in auto
mode).
DL8000 powers up for a

previously authorized batch
which was not in progress when
DL8000 powered down.
Note: If authorized batch was
running, flag resets.
Batch number reduces
by one.
Batch authorizes (in manual

mode).
Authorize Batch command

received (in auto mode).
Communications Protocols
Flag resets when...
Transaction authorizes (in

manual mode)
Authorize Transaction

command received (in auto
mode)
Prompt Additive command

received.
Additive selection screen is

prompted (in manual mode).
Operating mode changes.

DL8000 powers on.

Clear Status command received

(in auto mode with bit 05h).
Clear Status command received

(in auto mode with 0Eh bit).
Authorize Batch command

received (in auto mode).
Batch authorizes (in manual

mode).
Operating mode changes.

Batch ends (sets 0Dh).

Batch aborts.

DL8000 powers up.

Revised February-2016