Emerson DL8000 Instruction Manual page 148

DL8000 Preset Instruction Manual
End Transaction
Prompt Preset
Volume
D-20
Ends a transaction if a transaction is authorized. If a transaction is in progress
and the DL8000 archive module is running, then the system archives the
[0x07]
transaction and displays "Archiving Transaction" and "Please Wait" messages
before ending the transaction. If the transaction is not in progress (that is, not
a single batch is delivered in this transaction), then the transaction aborts.
DL8000 displays a "Please wait" message until it receives the next command.
If an operator presses Stop while a transaction is in progress and the batch is
not in progress or the batch is stopped, then the DL8000 sets the Transaction
End Requested flag (bit 19 in [63,0,119]) to indicate the request for a
transaction end. The TAS then can issue an End Transaction command.
Flags Immediately Set
Flags Immediately
Exceptions
Supporting
Parameters
Allows the TAS to let an operator enter a preset volume at the keypad.
Issuing this command locks the keypad and display to the TAS. The DL8000
displays a preset selection screen. If the suggested preset volume [63,0,185]
[0x08]
is greater than zero, the DL8000 "pre-types" the suggested preset volume.
The operator can press Enter to accept displayed preset volume or press Alt
+ Backspace to enter another preset volume.
The operator must enter the preset within the timeout time [63,0,171];
otherwise the operation aborts and sets the Operation Timed Out flag (bit 3 in
[63,0,119]).
If you set the timeout to zero, then the timeout doesn't occur. You must then
use the Timeout Operation command (0x05) to end this operation.
Flags Immediately Set
Flags Immediately
Exceptions
Supporting
Parameters
Communications Protocols
Transaction Ended
Transaction in Progress

Cleared
Transaction Authorized

Transaction End Requested

Batch in Progress

Operating Mode is Manual

No transaction authorized

None
Results The transaction ends; if the transaction aborts
without delivering a single batch, the system
reduces the transaction sequence number
[63,0,124] by one.
K&D Locked Out
Operation Timed Out

Cleared
Preset Volume Entered

Passcode Entry in Progress

Batch in Progress

Primary Alarm active

Operating Mode is Manual

No transaction authorized

K&D Locked Out

Suggested preset volume [63,0,185]

Preset volume entered [63,0,39]

Revised February-2016