Meter Totalizers (0X15) - Emerson DL8000 Instruction Manual

Primary Alarms
Meter Totalizers
Component Totalizers
Revised February-2016
Reset Deviations
[0x14]
Returns a non-resettable authorized flow from meter. In a blending
configuration (where more than one component may flow though a meter), it
[0x15]
is not always possible to determine which component generates unauthorized
flow.
Flags Immediately Set
Flags Immediately
Exceptions
Supporting
Parameters
Deviations
Returns non resettable component totalizers. In a blending configuration
(where more than one component may flow through a meter) it is not always
[0x16]
possible to determine which component generates unauthorized flow.
Flags Immediately Set
Flags Immediately
Exceptions
Supporting
Parameters
Some DL8000 alarms may not map directly to

DanLoad 6000 alarms.
Additional exceptions are supported such as

invalid alarm ID and Unable to reset the alarm.
DL8000 allows reset of non-primary alarms;

DanLoad 6000 allows reset of only primary
alarms.
Does not support the following DanLoad 6000

protocol alarms:
• Data logging memory full
• Memory Check Failure
• Primary Display Failure
• Secondary Display Failure
• MPMC 1 and MPMC 2 Failure
• Calibration Failure for all meters
• Intermediate Level Input
None
None
Cleared
None
Preset delivery type [63,0,29]
Results The response frame includes the following
parameter values:
Number of meters [63,0,20]

Meter Authorized Gross Total [75,x,15]

Meter Authorized Net std or Mass Total

[75,x,17 or 18] based on delivery type
The original DanLoad 6000-supported command
returns a snapshot of the free-running meter
totals. The DL8000 command returns free-running
authorized meter totals.
None
None
Cleared
None
Preset delivery type [63,0,29]
Communications Protocols
DL8000 Preset Instruction Manual
D-47