Video Loss Alarm - xmartO WNV14 User Manual

Wireless NVR System User Manual
3. Set the Sensitivity of motion detection.
4. Detection is set to be "Motion", choose the Alarm duration time and select the alarm type.
5. Set the stream type, detailed operation steps as below:
1) Choose "System setup" - "Channel Setup" - "Video Manage" - "Edit Channel".
2) Choose "Video Alarm" in the drop-down menu of stream type.
3) Click "Save" to save settings.
6. Click "Apply" to save settings.
7. Area edit allows users to exclude certain areas such as a frequently moving tree.
Tips:
 There are five grades of sensitivity: Highest, Higher, Moderate, Lower, Lowest. The higher the
sensitivity, the easier the moving object be detected.
 There are four types of motion detection alarm: Alarm, Buzzer, E-Mail Notice, FTP Upload.
 If choose Alarm as motion detection type, then you'll need to go to "Record Setup" - "Sensor
Setup" to set the operation mode as "Normally Open".
 If you set certain areas to be excluded from the detection areas, but still get alarm (such as
buzzer), it could be triggered by other channels. (channel 2, channel 3, channel 4...)

4.9.2 Video Loss Alarm

Function Description: Enable video loss alarm will allow users to get alarms when some of the
channels lost video.
Operation Steps:
1. Right click your mouse, to pop out NVR main menu, then click System setting – CH Setting – Video
Detection.
Image 53
46