System Operation Introduction; Starting Up/ Login/ Logout/ Reboot/ Close Screen Display/ Shutdown; Starting Up - xmartO WNV14 User Manual

Wireless NVR System User Manual

4. System Operation Introduction

4.1 Starting up/ Login/ Logout/ Reboot/ Close screen display/ Shutdown

4.1.1 Starting up

Note:
· Please ensure the power input voltage fit the NVR's requirements and the NVR has correct ground
connection.
· Unstable power source may cause unstable working status or even damage the NVR. If you have
unstable power source in your area, please use voltage-stabilized power source.
Tips:
· Before power on the NVR, please connect the NVR to a monitor or TV.
Steps of starting up the system:
1. Connect NVR to a standalone monitor/TV via VGA or HDMI. (Laptop cannot be used as a monitor.)
2. Plug NVR to power, the power indicator on NVR front panel should light up and
you'll hear a beep.
3. If monitor is getting video output from NVR, you should see the starting page as
shown in Image 7. If not, please check connection.
Note: If you cannot get any display on TV, please check here
http://www.xmarto.com/helpcenter/?/question/11 or contact xmartO support.
Image 7
11