Auto Add - xmartO WNV14 User Manual

Wireless NVR System User Manual
Image 17
Note:
 Connect Success: Camera is paired to NVR successfully; you should be able to see the camera
video on your monitor.
 No Video Source: Unoccupied channel, no camera is paired to this channel, you can pair a new
camera to this channel.
 IPC Disconnect: Camera is paired to NVR but not connected successfully.

4.3.2.2 Auto Add

Function: Find all cameras back quickly after upgrade NVR firmware, or configure camera to work
wired with NVR.
Add One is different from Match Code. Match Code configures the cameras to connect with NVR
wirelessly, while Add One configures the cameras to work wired with NVR.
When use Auto Add：
a. If some of the cameras' mounting spots are out of WiFi range, you need to wired connect
cameras to NVR to get image.
b. After upgrade NVR firmware, you can use Auto Add to find all cameras back.
Configure the camera to work wired：
1） Right click the mouse to pop out NVR main menu, click "Device Manage" to enter Device Manage
interface. Delete the camera from its current channel by select the channel and click "Delete".
2） Connect camera to NVR with network cable, plug camera to power, click "Refresh" on upper right,
Image 18
18