Channel Setting (Ch Setting); Encode Setting - xmartO WNV14 User Manual

Wireless NVR System User Manual
your system freezes up during Dream Line building, wait patiently till it goes back to operable
status. If it stays freezing, unplug power and enter the repeater setting page again.
 Cameras and NVR stay connected to constant power.
 NVR needs to stay ONLINE.
 Move cameras to the same room with NVR, or close enough to ensure they receive data and
command from NVR constantly.
 Need more information about Dream Liner? Check here:

4.4 Channel Setting (CH Setting)

4..4.1 Encode Setting

Function: Set the IP Camera information, including stream, resolution, rate, frame rate, frame rate
interval, H.264 coding grade, etc.
Operation Steps:
1) Right click the mouse to pop out NVR main menu, then click Device Manage – CH Setting, you'll
see below interface, as shown in image 26.
2) Switch the channel, and you can check all channels' information here.
Tips:
 Users are not allowed to edit the channel information here.
http://www.xmarto.com/dreamliner
Image 26
24