Operation System Introduction; Starting Up/ Log In/ Log Out/ Restart; Starting Up - xmartO WOS1388 User Manual

Wireless NVR System User Manual

4. Operation system introduction

4.1 Starting up/ log in/ log out/ restart

4.1.1 Starting up

Note:
· Please ensure the input voltage fit the NVR's requirements and the NVR has correct ground
connection.
· Unstable power source may cause unstable working status or even damage the NVR. If you have
unstable power source in your area, please use voltage-stabilized power source.
Tips:
· Before power on the NVR, please connect the NVR to a monitor or TV.
Steps to start the system:
1. Plug in the power to NVR, the power indicator on front panel should light up.
2. Turn on the power switch at the rear panel. If the screen is getting output from
NVR, you should see the starting page as shown in Figure 7. If not, please check
connection.
Image 7
11