Related Manuals for HAMPTON BAY Palisades
Summary of Contents for HAMPTON BAY Palisades
-
Page 1: Ceiling Fan
Palisades Ceiling Fan Owner’s Manual Palisades Ventilador de Techo de 1,32 Manual del Propietario... -
Page 2: Table Of Contents
52” Palisades Thank you for purchasing this Hampton Bay ceiling fan. This product has been manufactured with the highest standards of safety and quality. The finish Ceiling Fan by Hampton Bay of this fan is weather resistant, but over time will naturally weather and fade. -
Page 3: Safety Rules 1
READ AND SAVE THESE INSTRUCTIONS To reduce the risk of electric shock, insure electricity To avoid personal injury or damage to the fan and other items, has been turned off at the circuit breaker or fuse box be cautious when working around or cleaning the fan. before beginning. -
Page 4: Unpacking Your Fan
Unpack your fan and check the contents. You should have the following items: Mounting Hardware 1. Mounting Plate (inside canopy) 7. Blades (5) (1 hanger pin, 1 locking pin, 2. Canopy 8. Blade Bracket 1 rubber gasket) 3. Ball/Downrod Assembly 9. -
Page 5: Tools Required
Figure 4 SUPPORT OF LIGHTING FIXTURES MAY NOT BE ACCEPTABLE FOR FAN SUPPORT AND (available at your Hampton Bay retailer). MAY NEED TO BE REPLACED. CONSULT A LICENSED ELECTRICIAN IF IN DOUBT. Installing Your Fan 3. -
Page 6: Hanging The Fan
Hanging the Fan Standard Ceiling Mounting 4. Route the wires exiting the top of the fan motor through the decorative motor collar 1. Loosen the 2 screws in the collar on the REMEMBER turn pow- cover then the canopy ring. Make sure the top of the motor assembly er. - Page 7 “Close-to-Ceiling” Mounting 6. Align the mounting holes with the holes Mounting Screws in the motor and fasten, using the three (Supplied With 1. Remove the canopy ring from the canopy screws and lock-washers removed in step 4 Outlet Box) by turning the ring to the right until it (Figure 10).
- Page 8 Installing Fan to 1. Connect the two green fan ground wires lo- cated on the downrod and mounting plate the Outlet Box to the household ground wire. When using Close-to-Ceiling mounting, there is only one green ground wire from the ceiling WHEN MOUNTING ON A SLOPED CEILING, mounting plate since the ball/downrod as- MAKE SURE THE MOUNTING PLATE SLOTS...
- Page 9 SUPPLY CIRCUIT ELECTRICAL DIAGRAMS ARE FOR REFERENCE ONLY. OPTIONAL USE OF ANY LIGHT KIT SHALL BE UL LISTED AND MARKED SUITABLE FOR USE WITH THIS FAN. Finishing the Fan Outlet Box Installation Green Grounding STANDARD CEILING MOUNTING Lead WHEN USING THE STANDARD BALL/DOWNROD Ground to MOUNTING, THE TAB IN THE RING AT THE BOT- Downrod...
- Page 10 Attaching the CLOSE-TO-CEILING MOUNTING Fan Blades 1. Carefully unhook the fan from the mounting plate and align the locking slots of the ceiling canopy with the two screws in the mounting 1. Attach the blade to blade bracket using the plate.
- Page 11 Blade Balancing assembly by connecting the molded adaptor plugs together (blue to black, white to white). Carefully tuck all wires and splices All blades are grouped by weight. Because nat- Reverse Switch ural woods vary in density, the fan may wobble into the switch cup.
-
Page 12: Fan Without Light Kit
Fan Without Light Kit 1. In order to use the fan without the light kit, remove the switch cup cover from the top of the light kit by removing the center hex nut inside the switch cup cover, and then thread Reverse the switch cup cover off of the threaded Switch... -
Page 13: Operating Your Fan 11
Turn on the power and check the operation of the fan. The pull chain controls the fan speeds as follows: 1 pull - High, 2 pulls - Medium, 3 pulls - Low and 4 pulls - Off Speed settings for warm or cool weather depend on factors such as room size, ceiling height, number of fans, and so on. -
Page 14: Care Of Your Fan
Troubleshooting Care of Your Fan Here are some suggestions to help you Problem Solution maintain your fan. Fan will not start Check main and branch circuit fuses or breakers 1. Because of the fan’s natural movement, Check line wire connections to the fan and switch wire connections in some connections may become loose. -
Page 15: Specifications 13
GROSS FAN SIZE SPEED VOLTS AMPS WATTS CUBE FEET WEIGHT WEIGHT 0.25 14.7 2160 24.4 Lbs 27.9 Lbs 52” 0.37 31.0 3498 2.3’ (11.1 kg) (12.7 kg) High 0.52 62.1 5415 These are approximate measures. They do not include Amps and Wattage used by the light kit. Distributed by Your Other Warehouse LLC 12100 Little Cayman Dr. -
Page 16: Warranty Information
You must present a copy of the original Hampton Bay also warrants that all other fan parts, excluding any glass or acrylic blades, to be free purchase receipt to obtain warranty service.