4.14
Time Synchronization
Readout in the
HMI
7SJ63 Manual
C53000-G1140-C120-1
Time tracking in a SIPROTEC
q
DCF77 Radio Receiver (Time Signal from PTB Braunschweig),
q
IRIG-B Radio Receiver (Time Signal from the global positioning satellite (GPS) sys-
tem),
q
Signals via the system interface from SCADA, for example,
q
Radio clock using a system-specific synchronizer box,
q
Minute impulses on a binary input.
Time signal generators are connected via a 9-pin D-subminiature port on the back
panel of the device.
Setting of the time synchronization is done exclusively with DIGSI
• Double click on 7LPH 6\QFKURQL]DWLRQ in the data window and enter the set-
tings.
®
Figure 4-25
DIGSI
4 Setting of the Time Synchronization, example
®
Using the SIPROTEC
4 device HMI, the time synchronization settings can be
checked: 0DLQ 0HQX → 6HWWLQJV → 6HWXS([WUDV → &ORFN 6HWXS.
6(783(;75$6
'DWH7LPH
²!
&ORFN 6HWXS
²!
6HULDO 3RUWV
²!
'HYLFH,'
²!
0/)%9HUVLRQ
²!
&RQWUDVW
²!
Figure 4-26
Readout of Time Synchronization Settings from the HMI
®
4 device can be implemented using:
&/2&. 6(783
2IIVHW
(UURU 7LPH
6RXUFH
SIPROTEC 4 Devices
®
4:
ka455.gif
.
PLQ
PLQ
,QWHUQDO
4-33