Table of Contents
Advertisement
:
From PC with
®
DIGSI
4
7SJ63 Manual
C53000-G1140-C120-1
0($685(0(17
!6HW 3RLQWV 09
!5HVHW
3: 6HWWLQJV"
$UH <RX 6XUH"
!<(6 12 (VFDSH
Figure 7-25
Setting Limit Values at the Front Panel — Example
To change a limit value, mark the specific value using the
press the
key.
ENTER
A request for Password No. 5 (for settings parameters) is given. After password entry
and confirmation with the
cursor. Overwrite the previous value with the desired new value using the number
keys. If the entered value is outside the allowable value range, then the maximum or
minimum limit value appears at the bottom of the display.
Press the
ENTER
key. The new value appears in the list of limit values.
Other limit values can be changed in the same manner.
Upon leaving this level using the
appears, with the default answer "<HV" (Figure 7-25). Confirm with the
value should become effective. If a change to the value is not desired, press the
key so that the answer "1R" is marked, and confirm this with the
the value, mark "(VFDSH", confirm this with the
The metered value groups are found under 0HDVXUHPHQW (Figure 7-2) with a double
click. Select 2WKHU and then 6HW 3RLQWV 0HDVXUHG 9DOXHV .
Note: Set points are only in online–mode available!
By double clicking on an entry in the list view in the right side of the window, the limit
values are loaded. Mark the number of the value that is to be changed. With the right
mouse button, open the context menu and click on 6HW, as shown in Figure 7-26. A
password inquiry (password for individual settings) occurs. Next, the dialog field 6HW
0HWHUHG 9DOXH is opened. Enter the desired value in the entry field. Then click on
2..
The entered value is transferred to the device and the display within the window in Fig-
ure 7-26 is updated.
6(7 32,176 09
,$ GPG!
Enter Password No. 5 (individual settings)
ENTER
and confirm with
,/
ENTER
key, the previous value appears in a box with a flashing
ENTER
keys, the safety inquiry "$UH \RX VXUH""
or
MENU
ENTER
Operators Tools
!
Etc.
ENTER
and
keys, and then
ENTER
key if the
key. To correct
ENTER
key, and enter the value again
ENTER
7-23
Advertisement
Table of Contents
