Table of Contents
Advertisement
Installation and Commissioning
8-16
Factory jumper settings for the Pickup Voltages of the binary inputs BI8
Table 8-6
through BI20 and BI25 through BI37on the I/O-2 board
Binary Input
BI13
BI30
BI14
BI31
BI15
BI32
BI16
BI33
BI17
BI34
BI18
BI35
BI19
BI36
BI20
BI37
1
) Factory settings for devices with power supply voltages of 24 VDC to 125 VDC.
2
) Factory settings for devices with power supply voltages of 110 VDC to 220 VDC and 115 VAC.
Jumpers X71, X72 and X73 on the I/O-1 board and the I/O-2 board serve to set up the
bus address. The jumpers must not be changed. Table 8-7 and Table 8-8 show the
factory settings for the jumpers.
Table 8-7
Factory Settings for Jumpers X71, X72, and X73 on the I/O-1 Board
Jumper
1
/
Size and Full Size Housing
2
X71
X72
X73
Table 8-8
Factory Settings for Jumpers X71, X72, and X73 on the I/O-2 Board
Jumper
1
/
Size Housing
2
X71
2-3
X72
1-2
X73
1-2
The X3 and X4 jumpers for configuring the terminating resistors of a serial interface
are on a card that is located on the CPU board. The card is attached to the associated
serial port at location "B" or location "C" (designated on the rear of the 7SJ63). See
Figures 8-11 (RS 232/RS 485 Interface) and 8-12 (Profibus-Interface). The jumper
settings for the alternatives RS 232 or RS 485 (see Figure 8-11) are derived from Ta-
ble 8-9. Jumpers X3 and X4 must always have the same setting. The factory settings
for the jumpers are 1-2.
Jumper
17 VDC Pickup
X26
X27
X28
X29
X30
X31
X32
X33
L
H
L
Full Size Housing
Slot 33
1-2
2-3
2-3
1
)
73 VDC Pickup
1-2
2-3
1-2
2-3
1-2
2-3
1-2
2-3
1-2
2-3
1-2
2-3
1-2
2-3
1-2
2-3
Slot 5
1-2
1-2
2-3
7SJ63 Manual
C53000-G1140-C120-1
2
)
Advertisement
Table of Contents
