Table of Contents
Advertisement
2.6 using the Remote Control
To use the remote control, point it towards the front of the digital receiver. The remote control has a
range of up to 7 metres from the receiver at an angle of up to 60 degrees.
The remote control will not operate if its path is blocked.
NOTE:
Sunlight or very bright light will decrease the sensitivity of the remote control.
3.0 CONNECTIONS
3.1 basic connection with SCART cable
3.2 Connecting to Satellite Dish
Connecting a fixed satellite dish to your receiver
Connecting multiple fixed dishes to your receiver using a DiSEqC 1.0 switch
3.3 Connecting to a Digital Audio Amplifier
Connect your Digital Audio Amplifier with the S/PDIF connector on the back of the receiver.
3.4 Connecting to uSb device
4.0 fIRST TIME INSTALLATION
Ensure your satellite signal is of good quality. It is recommended that you perform the first time
installation by following the Installation as described step by step. It will help you to easily achieve
system configuration and installation setup.
4.1 OSD Settings
Press OK pq and tu to change settings for OSD Language, Audio Language, Subtitle Language, AUTO
Standby, Auto Time Zone and Time Zone.
4.1.1 OSD Language
Use this option to change the language of the OSD. Use tu to select OSD language.
4.1.2 Audio Language
Use this option to change the language of the Audio. Use tu to select Audio language.
4.1.3 Subtitle Language
Use this option to change the language of Subtitles. Use tu to select Subtitle language.
6
PART 1 • English
Fig. 4
Fig. 6
Fig. 7
Fig. 8
Fig. 7
Fig. 9
Advertisement
Table of Contents
