Technicolor TG589vac Setup And User Manual page 69

Poor Wireless Connectivity or Range
Try the following:
Check the signal strength, indicated by the wireless client manager. If the signal is low, try to reposition the TG589vac for

optimal performance.
Change the wireless

Use WPA(2)-PSK as encryption.

For more information, see
Change the wireless channel
Proceed as follows:
1 Browse to the TG589vac web
For more information, see
2 Click Wireless. The Wireless page appears.
3 In the Channel list under Interface, click a channel other than displayed in Current channel.
4 Click Save.
Cannot connect via WPS
If you have trouble connecting your wireless client via WPS, try one of the following:
The WPS session only lasts 2 minutes, make sure to press the WPS button on both devices within this time slot.

Wait until the WPS LEDs of the TG589vac and other devices are off and then try again.

Move the devices closer to each other.

Make sure that WPS is enabled on the TG589vac. Proceed as follows:

a Browse to the
For more information, see
b Click Wireless. The Wireless page appears.
c On the left menu, select the access point to which you want to connect using WPS.
d In the upper-right corner, click show advanced.
e Under Access Point, make sure that:
Broadcast SSID is switched to

WPS is switched to

Security mode is not WEP.

f If you made changes, click Save.
If the problem persists, configure your wireless client manually. For more information, see
wireless client" on page
DMS3-CTC-25-226 v1.0. Copyright © 2016 Technicolor. All rights reserved.
This document contains Technicolor proprietary and confidential information. Passing on and copying of this document, use, extraction and
communication of its contents, is not permitted without written authorization from Technicolor.
channel.
"3.4 Securing your wireless connection" on page
interface.
"4.1.1 Accessing the TG589vac web interface from your local network" on page
TG589vac web interface.
"4.1.1 Accessing the TG589vac web interface from your local network" on page
.
.
27.
29.
"3.2 How to manually connect a
7 Support
34.
34.
65