Connecting Your Wired Devices - Technicolor TG589vac Setup And User Manual

2.3 Connecting your wired devices

To connect wireless clients, see
To connect a set-top box for digital TV, first look for instructions in the documentation included in your package.
In some cases the set-top box will have to be connected to a dedicated Ethernet port (typically Ethernet port 4).
Requirements
Both your network device (for example, a computer, a gaming console,...) and your TG589vac must have a free Ethernet

port.
Your network device must be configured to obtain an IP address automatically. This should be the default setting.

Ethernet cable
In your package, you may find one or more cables with yellow connectors. These are Ethernet cables that you can use to
connect a local network device (a computer, an Ethernet printer, etc.).
Procedure
Proceed as follows:
1 Connect one end of the Ethernet cable to one of the yellow Ethernet ports of your TG589vac:
2 Connect the other end of the Ethernet cable to your network device.
Your TG589vac does not support Power over Ethernet (PoE). All network devices that are connected to the
TG589vac must be powered by their own power source.
3 Your device is now connected to your network.
DMS3-CTC-25-226 v1.0. Copyright © 2016 Technicolor. All rights reserved.
This document contains Technicolor proprietary and confidential information. Passing on and copying of this document, use, extraction and
communication of its contents, is not permitted without written authorization from Technicolor.
"3 Wireless networking" on page
2 Setting up your TG589vac
23.
17