Technicolor TG589vac Setup And User Manual page 58

How to set up content sharing
Both the Samba and the DLNA server are enabled by default. The only thing that you need to do is to plug your memory
stick or external hard disk in (one of) the USB port(s) of your TG589vac.
Customizing the content sharing settings
To change the default settings, proceed as follows:
1 Browse to the TG589vac web interface.
For more information, see
2 Click Content Sharing. The Content Sharing page appears. Under General status, you can change the following
settings:
Samba name:

Your TG589vac will share the content to the Samba devices under this name.
 Samba enabled:
Allows you to enable or disable the Samba file sharing server.
 DLNA enabled:
Allows you to enable or disable the DLNA service.
DLNA name:

Your TG589vac will share the content with other DLNA devices under this name.
3 When you click show advanced, you will be able to configure the Samba name and DLNA name. On top of that you
can also change the:
 Samba workgroup:
Enter the same workgroup as used by your computer(s).
 Samba description:
Add a short description for the TG589vac shared content.
4 Click Apply.
5 All users connected to your TG589vac can now access the data stored on the storage device(s) that are connected to
your TG589vac.
DMS3-CTC-25-226 v1.0. Copyright © 2016 Technicolor. All rights reserved.
This document contains Technicolor proprietary and confidential information. Passing on and copying of this document, use, extraction and
communication of its contents, is not permitted without written authorization from Technicolor.
"4.1.1 Accessing the TG589vac web interface from your local network" on page
5 Sharing content
34.
54