Powering On Your Tg589Vac - Technicolor TG589vac Setup And User Manual

2.2 Powering on your TG589vac

Only use the power supply unit that is supplied with your TG589vac. If your current power supply unit is broken,
contact your service provider or reseller.
Procedure
Proceed as follows:
1 Plug the connector of the power supply unit into your TG589vac power inlet port (
2 Plug the power supply unit into a nearby power outlet.
3 Press the power button to turn on your TG589vac.
4 The LED turns on. Wait at least two minutes to allow your TG589vac to complete the startup phase.
DMS3-CTC-25-226 v1.0. Copyright © 2016 Technicolor. All rights reserved.
This document contains Technicolor proprietary and confidential information. Passing on and copying of this document, use, extraction and
communication of its contents, is not permitted without written authorization from Technicolor.
2 Setting up your TG589vac
).
16