Location; E.5.2 Location - TESTO 340 Instruction Manual

E.5.2 Location

Creating a new location:
A location is always created in a folder.
1 Select the folder
2 Select the
Location name
3 Enter values
4 Repeat steps 2 and 3 for the other criteria accordingly.
5
OK Go to measurement
Ordering the locations list:
1 Select the folder
2
Locations list
Activating a location:
Select the folder
- The location is activated and the
Restoring the locations list:
To arrange the list in the order in which the folders were created:
Select the folder
Delete a location:
1 Select the folder
2 Select the location
3 Select
Delete site with data
Performing location settings:
For flow speed, air flow and mass flow to be measured correctly, the shape and surface
area of the cross-section must be set.
The parameters
Pitot factor
flow and mass flow. The pitot factor depends on the type of pitot tube that is used.
The offset factor should be set at 1.00 for all standard applications.
OK New location
Change
OK Save input OK
or
OK To location
.
OK
.
OK
Select location
OK
Measurements
OK Restore list
.
OK
.
Edit
OK
and
Offset factor
.
OK
.
.
.
OK
.
OK
menu is opened.
.
OK
.
influence the measurement of flow speed, air
E. Operation 23