Servo Cable Removal And Installation; Vacuum Reservoir Removal And Installation - Jeep Cherokee 2000 Service Manual

8H - 6 SPEED CONTROL SYSTEM
REMOVAL AND INSTALLATION (Continued)
REMOVAL
(1) Disconnect and isolate negative battery cable
from battery.
(2) Remove airbag module. Refer to Group 8M,
Passive Restraint Systems.
(3) From underside of steering wheel, remove
speed control switch mounting screw (Fig. 3).
Fig. 3 Speed Control Switch Remove/Install
1 – MOUNTING SCREW
2 – SPEED CONTROL SWITCH
(4) Remove switch from steering wheel and unplug
electrical connector.
INSTALLATION
(1) Plug electrical connector into switch.
(2) Position switch to steering wheel.
(3) Install switch mounting screw and tighten to
1.5 N·m (14 in. lbs.) torque.
(4) Install airbag module. Refer to Group 8M, Pas-
sive Restraint Systems.
(5) Connect negative battery cable to battery.
SERVO CABLE
REMOVAL
(1) Disconnect negative battery cable at battery.
(2) Using finger pressure only, remove cable con-
nector by pushing connector off the throttle body
bellcrank pin (Fig. 4). DO NOT try to pull cable
connector off perpendicular to the bellcrank
pin. Connector will be broken.
(3) Two release tabs are located on sides of speed
control cable at cable bracket (Fig. 4). Squeeze tabs
together and push cable out of bracket.
(4) Unclip cable from cable guide at valve cover.
(5) Disconnect servo cable at servo. Refer to Speed
Control Servo Removal/Installation.
Fig. 4 Speed Control Servo Cable at Throttle Body
1 – ACCELERATOR CABLE
2 – OFF
3 – OFF
4 – THROTTLE BODY BELLCRANK
5 – SPEED CONTROL CABLE
6 – RELEASE TABS
7 – BRACKET
INSTALLATION
(1) Attach end of cable to speed control servo.
Refer to Speed Control Servo Removal/Installation.
(2) Install cable into cable bracket (snaps in).
(3) Install cable
bellcrank pin (snaps on).
(4) Clip cable to cable guide at valve cover.
(5) Connect negative battery cable to battery.
(6) Before starting engine, operate accelerator
pedal to check for any binding.
VACUUM RESERVOIR
REMOVAL
The vacuum reservoir is located behind right front
bumper end cap on vehicles equipped with LHD (Left
Hand Drive) (Fig. 5). It is located behind left front
bumper end cap on vehicles equipped with RHD
(Right Hand Drive).
(1) Remove front bumper end cap. Refer to Front
Bumper End Cap Removal/Installation.
(2) Remove vacuum line at reservoir (Fig. 6).
connector at throttle
XJ
body