Horn Removal - Jeep Cherokee 2000 Service Manual

XJ
REMOVAL AND INSTALLATION (Continued)
Fig. 3 Right Cowl Side Inner Trim Remove/Install
1 – RIGHT FRONT DOOR SILL
2 – COWL SIDE TRIM PANEL
3 – SCREW
4 – SILL TRIM
5 – FUSE ACCESS PANEL
6 – PUSH-NUT
(4) Push down firmly on the horn relay until the
terminals are fully seated in the terminal cavities in
the junction block receptacle.
(5) Position the trim onto the right cowl side inner
panel.
(6) Install and tighten the screw that secures the
right cowl side inner trim panel and right front door
sill trim to the door opening sill. Tighten the screw to
2.2 N·m (20 in. lbs.).
(7) Install and tighten the screw located above the
fuse access opening that secures the trim panel to
the right cowl side inner panel. Tighten the screw to
2.2 N·m (20 in. lbs.).
(8) Install the push nut that secures the right cowl
side inner trim panel onto the junction block stud.
(9) Install the fuse access panel by snapping it
onto the right cowl side inner trim panel.
(10) Reconnect the battery negative cable.
HORN
REMOVAL
(1) Disconnect and isolate the battery negative
cable.
(2) Raise and support the vehicle.
(3) Remove the front underbody splash shield.
NOTE: Remove the horn and its mounting bracket
from the vehicle as a unit. Do not remove the horn
from its mounting bracket.
(4) Remove the screw that secures the horn and
mounting bracket unit to the radiator closure panel
brace (Fig. 4).
Fig. 4 Horns Remove/Install
1 – MOUNTING BOLT
2 – HORN
(5) Lower the horn and mounting bracket unit far
enough to access and disconnect the wire harness
connector from the horn connector receptacle.
(6) Remove the horn and mounting bracket unit
from behind the front bumper.
HORN SYSTEMS 8G - 5